invert Screener code

When creating an alert on the MACD, i think it’s “Horizontal line” 🙂

I think it is the “horizontal zero line” 🙂

1 user thanked author for this post.

sam00075

When those two averages, above the horizontal line, cross each other, at that moment the zero line is also crossed…

1 user thanked author for this post.

sam00075

Is it not possible to add as a condition : When the Horizontal line is crossed ?

Or when that happens close to the Horizontal line ?

In my train of thought I put this condition in, namely:

c5=MACD[12,26,9](Close) Crosses Over 0 //The MACD baseline is touched, and broken to the upside.

What value is your horizontal line?

1 user thanked author for this post.

sam00075

Not sure, logically the baseline value should be 0,00 no ?

0,00 = 0

1 user thanked author for this post.

sam00075

Do i need to replace  0 by 0,00 in the code ?

It’s not necessary, but in principle it doesn’t matter…
When you try it, use: 0.00

1 user thanked author for this post.

sam00075

still not.

How to replace the MACD[12,26,9] by the MACD horizontal line in the code ?

c5=MACD[12,26,9](Close) Crosses Over 0 //The MACD

i tried this but didn’t work

c5=MACD[Horizontal line](Close) Crosses Over 0 //The MACD

 

If the horizontal line has no value, it cannot be used…
I think the conditions are good.
I’m going to sleep on it…

1 user thanked author for this post.

sam00075

Thanks a lot for your patience and time.

Very appreciated.

1 user thanked author for this post.

JS

I think i found it :

c5=MACDLine[12,26,9](Close) Crosses Over 0 //The MACD baseline is touched, and broken to the upside.

🙂 Just added “Line” in MACD

Hi Sam,

Normally a buy signal is when the “MACD” crosses over the “Signal line”…

(During this crossing, the value of the histogram is equal to zero and rising…)

 

1 user thanked author for this post.

sam00075

In any case, a nice combination of conditions in this screener…

1 user thanked author for this post.

sam00075

[Author]

Posts